Voltage[:Dc]:Range - HP E1312A User Manual

VOLTage[:DC]:RANGe

Parameters
Comments
Example
VOLTage[:DC]:RANGe?
Example
Chapter 3
[SENSe:]VOLTage[:DC]:RANGe <
measurements.
Parameter Name Parameter Type
range
< >
•
To select a standard measurement range, specify range as the input signal's
maximum expected voltage. The multimeter then selects the correct range.
•
selects the minimum range available with the
MIN
command: 100mV.
300V.
•
You must select a range using
•
Specifying a fixed range disables the autorange mode by setting
VOLT:DC:RANG:AUTO OFF
•
The
VOLT:DC:RANG
CONFigure command on the same function.
•
Condition:
*RST
Change the Range
CONF:VOLT:DC 0.85,MAX
VOLT:DC:RANG 9
READ?
enter statement
[SENSe:]VOLTage[:DC]:RANGe? [MIN|MAX]
numbers to the output buffer.
•
The present voltage range selected if
ranges available with the RANGe command are returned. For example, if
selects the 1V range, 1.0V is the range returned.
CONFigure
•
The minimum voltage range available with the
command (100mV) if
•
The maximum voltage range available with the
command (300V) if
Query the Measurement Range
VOLT:DC:RANG 1.0
VOLT:DC:RANG?
enter statement
range selects the range for DC voltage
>
Range of Values
numeric 100mV|1V|10V|100V|300V|
MIN|MAX|DEF
MAX selects the maximum DC voltage range available:
VOLTage:DC:RANGe
.
command overrides the range setting from a previous
VOLT:DC:RANG 300V
Function: DC volts; range selected: 1V; MAX
resolution.
Range selected 10V; MAX resolution.
Place multimeter in wait-for-trigger state and make
measurements; send readings to output buffer.
Enter readings into computer.
MIN or
MIN is specified.
MAX is specified.
Select 1V range.
Query multimeter to return the present range.
Enter value into computer.
Multimeter Command Reference
Default Units
VOLTage:DC:RANGe
before specifying resolution.
returns one of the following
MAX are not specified. Only the
VOLTage:DC:RANGe
VOLTage:DC:RANGe
volts
149