Voltage:ac:range:auto - HP E1312A User Manual

Example

VOLTage:AC:RANGe:AUTO

Parameters
Comments
Example
VOLTage:AC:RANGe:AUTO?
Example
Chapter 3
Query the Measurement Range
VOLT:AC:RANG 10
VOLT:AC:RANG?
enter statement
[SENSe:]VOLTage:AC:RANGe:AUTO <
function for AC voltage measurements.
Parameter Name Parameter Type
mode
< >
•
You can substitute decimal values for the
•
When autoranging is
measurement and selects the appropriate range.
•
If you explicitly select a range using
turned OFF .
•
In order to specify an aperture time of 10µs, you must select a fixed range
(e.g.,
VOLT:RANG:AUTO OFF
•
Related Commands:
•
*RST Condition:
Disable AC Voltage Autoranging
VOLT:AC:RANG:AUTO OFF
[SENSe:]VOLTage:AC:RANGe:AUTO?
voltage autorange mode is enabled or disabled: "
sent to the output buffer.
Query the Autorange Mode
VOLT:AC:RANG:AUTO OFF
VOLT:AC:RANG:AUTO?
enter statement
Select 10V range.
Query multimeter to return the present range.
Enter value into computer.
mode >
Range of Values
boolean OFF|0|ON|1
OFF
, the multimeter samples the input before each
ON
VOLTage:AC:RANGe
).
CONFigure , VOLTage:RANGe
VOLT:AC:RANG:AUTO ON
Disable autorange.
returns a number to show whether the AC
Disable autorange.
Query multimeter to return autorange mode.
Enter value into computer.
Multimeter Command Reference
enables or disables the autorange
Default Units
(" ") and (" ") parameters.
0 ON 1
autoranging is
" = ON , " " = OFF . The value is
1 0
none
145