Mounting Expansion I/O - Rockwell Automation Allen-Bradley 1769-OF8V Installation Instructions Manual

6. To allow communication between the controller and module, move the bus lever fully
to the left (4) until it clicks. Ensure it is locked firmly in place.
ATTENTION
7. Attach an end cap terminator (5) to the last module in the system by using the
tongue-and-groove slots as before.
8. Lock the end cap bus terminator (6).
IMPORTANT

Mounting Expansion I/O

ATTENTION
Minimum Spacing
Maintain spacing from
enclosure walls, wireways,
adjacent equipment, etc.
Allow 50 mm (2 in.) of space
on all sides for adequate
ventilation, as shown:
When attaching I/O modules, it is very important that the bus connectors
are securely locked together to ensure proper electrical connection.
A 1769-ECR or 1769-ECL right or left end cap must be used to terminate
the end of the serial communication bus.
During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls into the module could cause damage on power up.
Side
Compact 1769-OF8V Analog Output Module
Host Controller
Publication 1769-IN066D-EN-P - June 2010
Top
Bottom
5
Side