Launching The Drv84Xx_Drv82X2_Drv89X2-Evm Gui Application - Texas Instruments DRV84 EVM Series User Manual

Launching the DRV84xx_DRV82x2_DRV89x2-EVM GUI Application

5 Launching the DRV84xx_DRV82x2_DRV89x2-EVM GUI Application
Whether using the desktop or web version of the GUI, the user experience and steps covered below will be the
same. It is assumed the hardware setup steps in the previous section have already been completed.
1. Launch the GUI application using Chrome web browser or from your local desktop installation. Note you'll
have to log-in to the TI Dev Gallery
running from a web browser.
a. Hyperlink for running app in Chrome:
2. Select the desired EVM type from the screen referenced in
Device selection screen within GUI.
For DRV8461EVM, DRV8462EVM, and DRV8462VEVM click on "DRV846xEVM"
For DRV8962EVM and DRV8962VEVM click "DRV8962EVM"
For DRV8262EVM and DRV8262VEVM click "DRV8262EVM"
Figure 5-1. DRV84xx_DRV82x2_DRV89x2-EVM GUI Home Screen
There is not an EVM for the DRV8452, DRV8952, or DRV8252 devices. You can make one by
swapping out the DRV8x62 chip with the matching DRV8x52 chip on its EVM, change ID3 resistor
to the LOW (GND) position, and change the ID4 resistor to the HIGH (3.3V) position.
3. After clicking the correct EVM type, the GUI application will initiate communications with the EVM.
Connection confirmation will be displayed as shown below in
10 DRV84xx_DRV82x2_DRV89x2-EVM User's Guide
using your myTI log-in credentials prior to launching the app while
Web GUI
Figure 5-1
Note
Copyright © 2023 Texas Instruments Incorporated
Figure 5-2:
SLOU558B – AUGUST 2022 – REVISED FEBRUARY 2023
www.ti.com
Submit Document Feedback