Event Settings; Alarms - OpenEye OE-C1011D4-S User Manual

EVENT SETTINGS

Alarms

Motion Detection
Motion detection is used to detect motion in a specified area during a period of time. The use of motion
detection requires setting a snapshot area, detection sensitivity, object size, and history. When these
requirements are met, the motion detection alarm will activate.
To configure Motion Detection:
1. Click + in Snapshot Area and drag the detection box to the desired location on the camera image
and use the corner markers to adjust the size of the detection box as desired.
2. Use the Sensitivity and Object Size slider bars to adjust the motion detection parameters as
desired.
Sensitivity – This determines how many pixels have to change in order for the alarm to
consider motion to have occurred.
Object Size – This determines the area within the camera image that the motion must exceed
in order for the alarm to consider motion to have occurred.
Alarm Parameters
Suppress Alarm – After an alarm is triggered, the same alarm will not be reported again
within the designated time.
Clear Alarm – After the alarm is triggered:
Click Save and then select the Trigger Actions to occur once the motion detection alarm has
been triggered.
37821AB
a) If the same alarm is not triggered within the set time, the alarm will be
cleared and the same alarm can be reported again.
b) If the same alarm is triggered within the set time, the alarm will not be
cleared until the suppress alarm time expires. Then the same alarm can be
reported again.
43