Table of Contents
Advertisement
L I NKING TO AN XTR DRIVER
Terra Linear fixtures can operate directly from standard AC mains voltages (100 to 277VAC)
or alternatively can be connected to an Acclaim Lighting XTR Driver, enabling even longer
runs. Use an optional XTR Driver adapter cable (see page 4) to convert from XTR output
to Terra Linear input:
HIGH VOLTAGE
Always follow these steps when using XTR cabling:
• Ensure that the power input is isolated from the mains supply.
• At each connection, release the cover caps from both the socket and plug.
• Align the orientation marks of the socket and plug - and then push them together so that
the blue lock ring clicks fully into place.
• As each connection is made, ensure that the connector is fully locked onto the socket.
• Any unused output ports must have their cover cap securely fixed in place.
• Do not exceed the stated maximum fixtures in a daisy chain - see page 16.
• At the final fixture in a daisy-chain run, install an End Cap (see page 3) to
seal off the power bus and also correctly terminate the DMX control feed.
• To release a connection, ensure that the power input is isolated, then twist the blue lock
ring of the plug counter-clockwise to release the connection.
XTR Driver output port
HIGH VOLTAGE - Please
read and adhere to all of
the advice points listed
below.
WARNING - HIGH VOLTAGE
This device can use high voltages (up to 400VDC) which could
cause severe personal injury or death if misused:
• Always isolate power before connecting or disconnecting links.
• Installation to be carried out by certified electricians only.
• Use only approved cables and connectors.
• Check all connections are correctly made before energizing.
www.acclaimlighting.com
XTR Driver
adapter cable
Input to Terra
Linear (or a link
cable leading to a
Terra Linear)
13
Advertisement
Table of Contents
