Table of Contents
Advertisement
1.
Broadband ISP connection
A network with hidden SSID (network name) can
not be detected by other devices. If you want to
connect to a network with hidden network name,
highlight the Add new network option under the
Other options caption and press OK. To connect
to the network, enter its name, select the type of
security and then enter the password if it is
password-protected. You can also make your
network's name visible by changing the settings via
the modem's software.
A Wireless-N router (IEEE 802.11a/b/g/n/ac) with
simultaneous 2.4 and 5 GHz bands is designed to
increase bandwidth. These are optimised for
smoother and faster HD video streaming, file
transfers and wireless gaming.
The frequency and channel differ depending on the
area.
The transmission speed differs depending on the
distance and number of obstructions between the
transmission products, the configuration of these
products, the radio wave conditions, the line traffic
and the products that you use. The transmission
may also be cut off or may get disconnected
depending on the radio wave conditions, DECT
phones or any other WLAN 11b appliances. The
standard values of the transmission speed are the
theoretical
maximum
standards. They are not the actual speeds of data
transmission.
The location where the transmission is most
effective
differs
depending
environment.
The Wireless feature of the Display supports
802.11 a,b,g,n & ac type modems. It is highly
recommended that you should use the IEEE
802.11n communication protocol in order to avoid
any possible problems while watching videos.
You must change your modem's SSID when there
are any other modems around with the same SSID.
You can encounter connection problems otherwise.
values for the wireless
on
the
usage
Use a wired connection if you experience problems
with a wireless connection.
A stable connection speed is required to play back
streaming content. Use an Ethernet connection if the
wireless LAN speed is unstable.
Note: Android system allows only one network connection at
a time. If the Display is connected to the network both
wirelessly and via Ethernet (wired), the Ethernet connection
will take priority. Since if this is the case, a WLAN connection
can not be established. Unplug the Ethernet cable to allow
wireless connection.
Network Standby Mode
Networked Standby Mode is a standby that allows a
device to be turned on or woken up by a network
message (magic packet). This message is sent to the
device by a program executed on a remote device
connected to the same local area network, such as a
smartphone.
To enable this feature the Networked Standby Mode
option in the Network & Internet menu and the
Power Mode option in the Display Settings>Signage
Settings>Power Up Settings menu should be
enabled (Power Mode - Reactive). It is necessary that
both the device, from which the network message will be
sent to the Display, and the Display are connected to the
same network. All devices must support magic packet
on the system from Access Points to the device which
sends the magic packet and the device which receives
the magic packet to wake-up. You can use any
Networked Standby Mode software available for the
operating system of your device in order to send magic
packets.
In order to use this feature the Display and the remote
device should be connected at least once while the
Display is on. If the Display is powered off, the
connection should be re-established, the next time it is
switched on. Otherwise this feature will be unavailable.
This does not apply, when the Display is switched into
the standby mode.
How to control functionality
• Enable the Networked Standby Mode feature from
within the Network & Internet menu
• Connect your Display and the remote device, which
will send the magic packets to the Display, to the
same network
• Get the MAC address of your Display which will be
needed in order to send magic packets. Refer to
Connectivity section for information on how to get
the MAC address
• Switch the Display into standby mode
• Send magic packets to the MAC address of your
Display by using mobile phones, Linux or Windows
computers
Your Display should wake up after receiving magic
packets.
21
Advertisement
Table of Contents
