Table of Contents
Advertisement
• You can allow or restrict installation of apps from
sources other than the Google Play Store.
• Set the TV to disallow or warn before installation
of apps that may cause harm.
Accessibility: Configure Captions, Text to
speech, Accessibility shortcut settings and/or
turn High contrast text on/off. Some of the
caption settings may not be applied.
Restart:
A
confirmation
displayed, select Restart to proceed with restarting.
The Display will switch off/on first. Select Cancel to
exit.
Reset: Reset all Display settings to the factory
defaults.
Highlight Reset and press OK. A
confirmation message will be displayed, select
Reset to proceed with reset- ting. The Display will
switch off/on first and the initial setup will start.
Select Cancel to exit.
rd
Installing 3
party applications
Follow the below mentioned steps in order to install
a third party application.
• Copy the file with the extension ".apk" onto a FAT
formatted USB storage device
• Connect the USB storage device to one of the
USB inputs on the Display.
• Launch
the
AppInstaller
Applications menu on the Home Screen.
Highlight your connected USB storage device on
the next dialogue and press OK to search the
content for apk files. Highlight one of the found
files and press OK. Your permission will be
asked. Highlight INSTALL and press OK again
to proceed.
• You can access the installed applications from
the Applications menu on the Home Screen.
Note: Third party applications support is limited. Some
functions of the application or properly launch may be
affected as not being codded according to required Android
platform. Download processes via the open browser are not
supported.
Connectivity
To configure wired and wireless settings you
should access the Display Settings > Network &
Internet menu. Press the Menu button on the
remote to view the Display Settings menu.
To Connect to a Wired Network
There is an Ethernet socket on the rear side of your
Display.
Connect
modem/router via this Ethernet socket using an
Ethernet cable. Refer to the General View section
on the first pages of this manual to see the location
of the socket.
message
will
app
from
your
Display
to
The status of the Internet connection under the
Ethernet caption in the Network & Internet menu will
read 'Connected'. The MAC and IP addresses will
also be displayed under this caption.
be
1.
Broadband ISP connection
2.
Ethernet (LAN) cable
3.
Ethernet (LAN) input (on the rear side of the
Display)
To Connect to a Wireless Network
A wireless LAN modem/router is required to connect
the
the Display to a wireless network. If the Display is
connected to a wired network, unplug the Ethernet
cable to allow wireless connection.
Highlight the Wi-Fi option in the Network & Internet
menu and press OK to turn on the WLAN. Available
networks will be listed. Select one and press OK to
connect. You may be asked to enter a password to
connect to the selected network, in case the network
is password protected.
You can see the status of the connection under the
name of your network. It will read 'Connected' if the
connection is successful. Highlight your network
under the Available networks caption in the
Network & Internet menu and press OK to see the
detailed information on the connection such as
MAC and IP addresses. This way you can also
access
advanced
connection such as proxy and IP settings. You can
also use the Forget network option here to delete
the connected wireless network profile, so the
Display will not connect to that network automatically
if it is available when the WLAN option is turned on.
your
settings
for
the
wireless
20
Advertisement
Table of Contents
