Table of Contents
Advertisement
Connecting the external IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver (depends on the model)
to the IR input on the Display. Place the IR receiver in sight of your own remote control. Simply operate your
remote control whilst pointed at the IR receiver and it will relay the control signal to your Display.
In case your Display has touch screen feature and if the IR receiver is going to be placed on the Display it
shouldn't be placed facing the inside of the screen, otherwise the signals of the touch screen and the remote
may interfere with each other. To improve the performance of your remote control place the IR receiver as
shown in the drawing below.
Depending on the model, your Display may have a built-in IR receiver on its cabinet. This IR receiver will not
function if the external IR receiver is connected to the Display. Disconnect the external IR receiver if you want
to use the built-in IR receiver again.
Turning the Display On/Off
Connect power
IMPORTANT: The Display is designed to operate on 110-240V AC, 50/60 Hz socket.
After unpacking, allow the Display to reach the ambient room temperature before you connect it to the mains.
Plug the power cord into the mains socket outlet.
For models with detachable power cord
Plug one end (female connector - C13) of the supplied detachable power cord into the power cord inlet (AC IN)
on the rear side of the TV. Then plug the other end of the power cord into the mains socket outlet.
Turn on the power switch on the Display - position "1"
the power LED will light up.
To switch on the Display
If the Display is in standby mode or quick standby mode, the power LED lights up. To switch on the Display
either press the Standby button on the remote control or press the centre of the joystick in and hold it down
for a few seconds. The Display will then switch on.
To switch the Display into standby mode
In order to switch the Display into standby mode press and hold the Standby button on the remote control.
Power off dialogue will appear on the screen. Highlight OK and press the OK button. The Display will switch
into standby mode.
To switch the Display into quick standby mode
In order to switch the Display into quick standby mode either press the Standby button on the remote control or
press the centre of the joystick in and hold it down for a few seconds (while Home Screen is displayed). Press
the button again to go back to operating mode.
Note: If the Power Mode option (to be found in the Display Settings > Signage Settings > Power Up Settings menu) is
enabled (Reactive mode), the Display will switch into standby mode when the Standby button is pressed.
). The Display will switch into standby mode and
10
Advertisement
Table of Contents
