Zooming The Image; Using The Cursor On A 3D Image; Saving Waypoints - Lowrance HDS PRO Operator's Manual

Zooming the image

You can zoom the image.
The zoom level is shown on the image. If the cursor is active, the
system zooms in where the cursor is positioned.

Using the cursor on a 3D image

By default, the cursor is not shown on the image.
On a 3D image, select the Cursor Enable panel button to use the
cursor.
When the cursor is positioned on an image, the cursor information
window and the history bar are activated.
The cursor information window shows available data at the cursor
position, including the distance and range from the vessel to the
cursor position.
The history bar is used to pan back in the stored data. The
highlighted part of the History bar shows the image you are
currently viewing in relation to the total image history stored. Refer
to "Viewing image history" on page 111.
Ú Note:
The history bar can be turned off. Refer to "Clear live history"
on page 113.

Saving waypoints

To save a waypoint, position the cursor on the panel and then select
the new waypoint menu option.
109
3D Sonar | HDS Pro Operator Manual