FireBird Bio-Tec Manual page 20

Starting the boiler
1. Make sure that both chambers are reasonably clean
(see maintenance instructions)
2. Build a small 'kindling fire' with paper/firelighter and some
well-dried kindling
3. Close the lower chamber door
4. Turn on the MAIN SWITCH power switch and push the START
button. The fan will start up and the LED light next to the start
button will begin to flicker.
5. Light the kindling fire and close the upper door.
6. When a good glow has been created open the upper chamber
door and load with the desired amount of timber
7. Close the upper chamber door and again push the button
START. The boiler is now in gasification mode