Godex EZ-2200 Programmer's Manual page 8

7. Reset printer
Syntax : ~Z
Parameter : None
Description : Reset the printer, the LED will flash once.
8. Printer head testing
Syntax : ~T
Parameter : None
Description : Print a pattern for the user to determine if the print head is damaged (refer page 20)
9. Clear all
Syntax : ~MDEL
Parameter : none
Description : Clear all in the memory (not include Asia font)
10. Clear memory
Syntax : ~MDELx,name
Parameter : x = type
G, graphic
F, label form
E, Bit-Mapped font (not included Asia font)
name: The name of the graphic, form and Bit-Mapped font
Description : Able to delete individual files or erase entire flash memory.
Example : ~MDELG,Bus
11. Rotate printing
Syntax : ~Rx
Parameter : x = label width; from 1 to 104 (mm)
Description : Rotate the label format 180-degrees when printing (refer page 19). To return to the original
print direction, set the x value greater than 104 (ie. ~R105).
12. .Print the available space and data name in the memory
Syntax : ~Xn
Parameter : n = 1, print label format names and available space in memory.
n = 2, print graphic names and available space in memory.
n = 3, print Bit-Mapped font names and available space in memory.
n = 4, print the name of the label formats, graphics, fonts, and available space in memory.
n = 5, print Asia font names and available space in memory
n = 6,
Description : Print the available space in the memory card (unit: bytes)
13. Acknowledge from RS-232
Syntax : ~Kn
Pararmeter : n = 0, disable.
n = 1, enable.
Return value : Y8
Description : Acknowledge a "Y(0D0A)" from RS-232 back to host each printing label.
14. Row Offset Adjustment
Syntax : ~Q±n
Pararmeter : n=-36 ~ +36
Return value : none
Description : If the printing doed not appear in the same place on every label, this command instructs the
printer to print label formats +n increments above the position the format specifies, and –n
decrements below the position the format specifies.
; the graphic "Bus" will be deleted
display the total printed length on the LCD
7