Godex EZ-2200 Programmer's Manual page 6

10. Stripper sensor
Syntax : ^Ox
Parameter : x = 0 , stripper disable.
x = 1 , stripper enable
Description : Enable or disable the stripper sensor. When you use this command, it should be matched
with^Ex. (refer page 17)
11. Download label format
Syntax : ^Fname
data
Parameter : Name = name of label format (up to 20 characters)
Data = the data containing the label formatting command for this stored format
Description : Download label format into memory. After the download is finished, the printer will beep once
(refer page 20).
Same name inspection : If you use the same file name, the printer will print "REPEAT FILE
NAME", and the download will be not be accepted.
12. Recall label format
Syntax : ^Kname
Parameter : Name = name of recall label format (up tp 20 characters)
Description : Recall label format from external format (refer page 20)
^Kname
:
:
E
:
:
~Px
13. Label width setting
Syntax : ^Wxx
Parameter : x=label width (mm)
Description : Label width setting
14. Number of labels per cut
Syntax : ^Dx
Parameter : X = 0 , disable cutting.
X = 1 ~ 32767 , number of label per cut.
Description : Number of labels per cut (refer page 17)
15. Serial Port translation setting
Syntax : ^Yp1.p2,p3,p4
Parameter : p1 : Baud Rate (48 or 96 or 19 or 38) ; 48=4800bps; 96=9600bps; 19=19200bps;
38=38400bps
p2 : Parity (N, O, E)
p3 : Number of data bits (7 or 8)
p4 : Number of stop bits (1 or 2)
Description : Serial Port translation setting
^Fname
:
Control/Setup command
:
^L
data
:
Label format command
:
E
data
Control/Setup command [option]
; N=none parity; O=odd parity; E=even parity
5