Godex EZ-2000 PLUS User Manual page 43

Smart Backfeed
Password
Top of Form
Ethernet
Preview
【 】
Note 1
"Default Setting" is the original settings from the factory, if other changes are made on the
settings, then follow the new settings.
【 】
Note 2
Printer will store the previous settings after power off, thus if settings are to be changed again,
please enter the Setting Mode to reset.
EZ-2000+/6000+ User's Manual Rev. D
Default: ON
ON: This function must install stripper or cutter.
OFF
Default: OFF
ON: When password protect enable, the password is required
for entering Setting Mode.
OFF
Default: ON
ON: Start each printing from the Top-of-Form position.
OFF
Go to default: Set the IP address of Ethernet module to factory
default setting.
Preview and check all settings.
42