With LCD monitor
Press and hold
key about 3 to 4 seconds until the buzzer beep 3 times and LCD shows
Setting mode. The LCD monitor will show different options on the bottom.
Below are general descriptions of setting items.
Darkness
Speed
Stop Position
Printhead Position
Printing mode
Option Setup
Sensor Setup
EZ-2000+/6000+ User's Manual Rev. D
After entering to Setting mode, the first
highlight on LCD monitor indicates the
current item for setting.
In setting type, the first line indicates the
current item and the second line indicates
current setting.
In adjustment type, the first line indicates the
current item and the second line indicates
current value.
Plus: press
Minus: press
Next: press
Default: 15
Set the darkness of printing result. The setting value is from 0
to 19 and the default value is.
Set the speed of printing.
Default: 12
Set the stop position of printing. The setting value is from 0 to
60.
Default: 0
Set the position of print head when printing. The setting value
is from -100 to 100.
Default: Thermal Transfer
Thermal Transfer: when printing, a ribbon must be installed
to transfer the print contents onto the media.
Direct Thermal: when printing, no ribbon is necessary; it only
requires direct thermal media.
Default: Option OFF
Strip Mode: turn on the stripper function
Cutter Mode: turn on the cutter function
Applicator Mode: turn on the applicator function
None: select this to turn off the stripper and cutter functions.
Default: Gap paper
Black Mark: for label or plain paper with black mark in the
back
Gap: for labels with liner and gap, or hang tags. The default is
set to be gap paper.
Continuous: for continuous paper
40
key to increase the value
key to decrease the value
key to go to next item
Need help?
Do you have a question about the EZ-2000 PLUS and is the answer not in the manual?