Table of Contents
Advertisement
4.4. Installing and removing the cooling system
Remove the battery. Use lever to close the bottle valve. Put the bottle on the screws
(1). Attach the hose to the fitting (2). Check the operation of the cooling system. To do
this, loosen the bottle cap and open the valve using lever. Turn the handles to the left
to apply light pressure on the pilot pin. The coolant should fill the system and start
flowing from the cutter.
Remove cooling system in reverse sequence.
4.5. Checking the battery charge level
Charge the battery before first use.
To check the charge level, press the charge status button. If only one LED on the
charge indicator flashes green, charge the battery.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
This document is protected by copyrights.
12
Minibeast Cordless
1
2
Advertisement
Table of Contents
