Installing And Removing The Battery; Clamping Surface Requirements - JEI Minibeast Cordless Operator's Manual

Do not charge fully charged battery.
Before charging the battery, read the charger manual.
Charge status button
Charge indicator

4.6. Installing and removing the battery

Slide the battery in (1) until it locks into place. Press and hold the battery lock (2) to
remove the battery (3).

4.7. Clamping surface requirements

The ferromagnetic surface to which the drilling machine is clamped must be at least 6
mm (0.24") thick.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
4 LEDs light up green
3 LEDs light up green
2 LEDs light up green
1 LED lights up green
1 LED flashes green
1
This document is protected by copyrights.
13
Minibeast Cordless
≤ 100%
≤ 75%
≤ 50%
≤ 25%
charging required
3
2