Drilling; Finishing The Operation - JEI Minibeast Cordless Operator's Manual

4.11. Drilling

1. Press the Motor START button to start the motor.
2. Turn the handles to the left to put the tool into the workpiece. Do not change the
position of the drilling machine while making the hole.
When the annular cutter goes through the workpiece, the slug core is
pushed out with a large force.
3. After the hole is made, retract the tool from the workpiece. Press the Motor
STOP button to stop the motor.
4. Before you move the machine, set the MAGNET switch to 'O' to turn off the
base.

4.12. Finishing the operation

1. Turn off the motor and the base.
2. Remove the battery.
3. Clean the drilling machine and the tool.
4. Remove the machine from the work area.
5. If the cooling system is installed, remove the remaining coolant. To do this,
tighten the bottle cap, close the valve, and then press the pilot pin. Remove the
cooling system.
6. With gloves on, remove the tool from the arbor.
7. Put the machine in the box.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
Slug core
This document is protected by copyrights.
17
Minibeast Cordless