Preparing - JEI Minibeast Cordless Operator's Manual

4.10. Preparing

1. Clean steel parts, including the spindle, from the anti-corrosion material used to
preserve the machine during storage and transport.
2. Attach the handles to the feed shaft.
3. Put the machine on a workpiece.
4. Select the correct tool. Clean the spindle and the tool with a dry cloth. Install the
tool in the arbor.
5. For vertical drilling with an annular cutter install the cooling system and fill it with
coolant. Make sure that the cooling system works correctly.
6. Install the battery.
7. Set the MAGNET switch to 'I' to turn on the clamping. Check the LED indicator
to see if the clamping force is sufficient.
The operator takes full responsibility for working with low clamping
force.
8. Secure the machine with the safety strap.
9. Turn the handles to the left to put the tool above the workpiece.
10. Lower the chip guard to cover the tool.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
This document is protected by copyrights.
16
Minibeast Cordless