Table of Contents
Advertisement
4. STARTUP AND OPERATION
4.1. Tools compatible with drilling machine
The drilling machine can be used with tools listed in the following table.
Tool
Turbo Tough, TCT
annular cutter
Turbo Steel, HSS
annular cutter
Turbo Steel, Twist drill
bit
Turbo Steel, Countersink
4.2. Installing and removing the tool
Remove the battery. Lift the chip guard (1). Turn the handles to the right (2) to lift the
motor. When you install the annular cutter – use gloves to put the correct pilot pin into
the cutter (3). Use a dry cloth to clean the spindle and the tool. Put the tool into the
spindle (4) so that the flat surfaces (5) align with the screws (6). Use the 4 mm hex
wrench to tighten the screws. To remove the tool, loosen the screws.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
Maximum tool
diameter
36 mm (1.42")
"
30 mm (1.18
)
"
12 mm (0.47
)
"
30 mm (1.18
)
This document is protected by copyrights.
10
Minibeast Cordless
Application
Drilling through holes
Drilling through and
blind holes
Countersinking and
chamfering holes
Tool holder
"
19 mm (3/4
)
Weldon
Advertisement
Table of Contents
