Application Of A Cooling System - JEI Minibeast Cordless Operator's Manual

3
When you use an annular cutter, drill only through holes. Do not use
the pilot pin for incomplete through holes.

4.3. Application of a cooling system

The drilling machine is equipped with a gravity cooling system.
Install the cooling system when you drill vertically with an annular cutter. When you
use other tools or drill with an annular cutter in position other than vertical, use coolants
under pressure or in the form of spray or paste. Do not allow coolant to flow into the
motor.
Do not use pure water as coolant. You can use a mixture of water and drilling oil.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
1
6
4
5
Incomplete through holes
Complete through holes
This document is protected by copyrights.
11
Minibeast Cordless
2