Removing The Tool - JEI MAGBEAST HM140T Safety Instructions And Operator's Manual

Twist Drills:
Drills with MT3 connection can be directly fitted in the drill spindle.
For twist drills with MT2 connection use a reducing sleeve MT3 – MT2
For twist drills with parallel shank use a drill chuck B18 with appropriate taper mandrel MT3 – B18
Core Drills:
For working with core drills you need a mount MT3 – 0 19 Weldon
Fit the ejector pin of suitable length in the core drill.
Place the core drill in the Weldon mount so that the two allen screws hit the two surfaces of the
shaft.
Tighten the allen screws equally.
Attention!!
Never press the tool into the tool connection with might and main!
Morse tapper and – cone have to be free of grease and dirt.

REMOVING THE TOOL

Put the drill drift in the opening of the gearbox collar.
If you cannot insert the drill drift through the work spindle, turn the work spindle slightly.
Remove the tool from the work spindle by a slight impact on the drill drift.
9 | P a g e