AIRBEAST 35 ATEX
JEI GroupLtd
3. STARTUP AND OPERATION
All safety precautions must be closely observed.
3.1. Mounting and operation of annular cutter
With the machine unplugged from the supply, proceed as follows. Maximally raise the
chip guard (1, Figure 2) and rotate the feed lever counterclockwise (2) to access the
set screws 3. Then, insert the proper pilot pin into the annular cutter (4), after which
wear protective gloves and place the cutter into the arbor (5) in such a way to align the
flats 6 with the set screws 3. Finally, tighten both set screws with 4 mm hex wrench. To
dismount the cutter, proceed in reverse order.
AIRBEAST 35 ATEX Operator's Manual
7