WWW.JEIUK.COM
3. STARTUP AND OPERATION
All safety precautions must be closely observed.
3.1. Mounting and operating the annular cutter
Unplug the power cord from the power outlet and raise the motor by rotating the spoke
handles clockwise (1, Figure 3). Insert the proper pilot pin into the annular cutter (2), then
wear protective gloves and place the cutter into the arbor (3) in such a way to align the flats
4 with the set screws 5. Finally, tighten both set screws with the supplied 4 mm hex wrench.
To dismount the cutter, proceed in reverse order.
1
5
2
3
4
Figure 3. Mounting the annular cutter
This document is protected by copyrights.
8
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.