Kyocera ECOSYS PA6000 Series Operation Manual page 247

Troubleshooting > Troubleshooting
Symptom
While [Auto-IP] is already
set to [On], the IP address
is not assigned
automatically.
The machine is emitting
steam in the area around
the paper ejection slot.
Checkpoints
Is a value other than "0.0.0.0" entered
for the link local address of TCP/
IP(v4)?
Check the room temperature to see if
it is low, or if damp paper was used.
Corrective Actions
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
Depending on the printing
environment and the paper's
condition, the heat generated during
printing will cause the moisture in the
paper to evaporate, and the steam
emitted may look like smoke. This is
not a problem, and you can continue
printing. If the steam concerns you,
raise the room temperature, or
replace the paper with a newer, dryer
paper.
10-13
Reference
Page
page 2-17
―