Table of Contents
Advertisement
RBP-RC001-E Installation & Owner's Manual
I/O settings
You can assign functions for external inputs such as operation patterns and demand signals, as well as functions for external
signal outputs such as operation signals and failure signals.
Make sure that no digital noise is applied to the external I/O wiring.
For information about the I/O functions, refer to "I/O function list (P. 50)".
[CAUTION]
If the GR operation is set to "external" or the GR is "running", the setting cannot be changed. Stop the device beforehand.
Digital Input settings
Digital Output settings
1
On the setting screen, select "I/O settings" and press
[●] (Confirm).
2
Use [<] and [>] to select "Digital Input" and press
[●] (Confirm).
3
Use [Λ] and [V] to select the input terminal to set and
use [<] and [>] to change the input signal.
4
To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).
When you change the setting, GR will automatically restart.
1
On the setting screen, select "I/O settings" and press
[●] (Confirm).
2
Use [<] and [>] to select "Digital Output" and press
[●] (Confirm).
3
Use [Λ] and [V] to select the output terminal to set and
use [<] and [>] to change the output signal.
4
To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).
When you change the setting, GR will automatically restart.
40
32RCA001TS-02ISEN
Advertisement
Table of Contents
