When You Suspect A Failure - Toshiba RBP-RC001-E Installation & Owner's Manual

Group remote controller
Table of Contents

Advertisement

RBP-RC001-E Installation & Owner's Manual
If a failure occurs in the product, do not attempt to repair it yourself. Contact your dealer or local Toshiba Carrier representative.
Let us know the model, fault code, and contact No. (For the contact No., refer to the label attached to the product itself.)
The symptoms listed in the table below are not failures. Check the table beforehand.
Symptom
You pressed a button, but get no response.
Even during operation, the operation lamp is not
turned ON or the operating output is not turned
ON.
Even during stop, the operation lamp is not
turned OFF or the operating output is not turned
OFF.
Even though a failure has occurred, the failure
lamp is not turned ON or the failure output is not
turned ON.
Even though no failure has occurred, the failure
lamp is turned ON or the failure output is not
turned OFF.
The I/O function does not operate.
Device information is not displayed.

When You Suspect a Failure

•If you press any button while the backlight is OFF, the backlight is turned ON. Press
again the button you want to operate.
•This is a button whose operation is disabled. (The buzzer does not sound.)
•If you set the button to be long pressed, long press the button.
The operations of the operation lamp and the operating output vary depending on the
setting of the DN code "Level of operating output". Check the setting of "Level of
operating output".
•The operations of the failure lamp and the failure output vary depending on the
setting of the DN code "Level of failure output". Check the setting of "Level of failure
output".
•The I/O functions that output failures include "Failure output" and "Failure inverse
output", which outputs a states by inverting it. Check the I/O function settings.
I/O signals require an external power supply. Check if the external power supply is not
off.
• Check if the power supply to the connected device is not off.
• Check if the address setting of the connected device is correct.
Cause
53
32RCA001TS-02ISEN

Advertisement

Table of Contents
loading

Table of Contents