Connection To External Equipment - Toshiba RBP-RC001-E Installation & Owner's Manual

RBP-RC001-E Installation & Owner's Manual

Connection to External Equipment

Example of connection to external equipments
Name I/O Item
Contact A static signal
output
Contact permissible
voltage/current
Signal
DC 24 V/90 mA
output
Digital I/O Contact A static or
terminal pulse signal input
(It depends on the
input function settings.
For details, Refer to
the I/O function list (P.
50).)
Signal
input
A contact that supports
microcurrent must be
selected and used.
* Wire the cables so that the user does not touch the power supply directly.
* On the equipment side, use a basically insulated power circuit and place it in a location that where the user cannot touch it.
* Procure the external power supply for the digital I/O locally.
* Functions can be assigned to digital inputs 1 to 3 and digital outputs 1 to 2. Refer to "I/O settings (P. 40)"
* Group remote controller cannot be connected to equipment by our remote monitoring or open protocol (BACnet, Modbus).
[REQUIREMENT]
• Fasten the screws to the terminal block with torque of 0.5 N·m.
This unit side
I/O conditions Circuit
Output 2 DO2
Signal
DO1
Output 1
DI3
Input 3
Signal DI2
Input 2
DI1
Input 1
Terminal
name
+VS
DO1
DO2
DI1
DI2
DI3
COM
11
32RCA001TS-02ISEN
Input / output
COM
l ( )
Input / output
+VS
l ( )
G
B
A
Equipment side
Circuit example I/O conditions
External
power
+
supply DC
-
12V or 24V
Digital
input
Pulse width of
pulse signal
input: 500 ms or
more
External
power
supply
input