Toshiba RBP-RC001-E Installation & Owner's Manual page 31

RBP-RC001-E Installation & Owner's Manual
Operation Settings
Set the operation conditions for each GR system.
Operation settings screen
List of "Operation Settings" setting items
Item
MC Gr.Ctrl
Mode
Cool PST
Heat PST
Demand
Set temperature input screen
Set MC group control to ON/OFF.
MC Gr.Ctrl OFF: Operate all MCs in the same system.
MC Gr.Ctrl ON: Control the number of MCs to operate in the same system according to load.
Operation procedure:
Use [Λ], [V], [<], and [>] to select the system to change and press [●] (Confirm) to switch between ON and
OFF.
Switch the mode between Stop, Cool, and Heat.
Operation procedure:
Use [Λ], [V], [<], and [>] to select the system to change and press [●] (Confirm) to switch between Stop, Cool,
and Heat.
Set the set temperatures for Cool/Heat.
Operation procedure:
1 Use [Λ], [V], [<], and [>] to select the system to change and press [●] (Confirm) to display the set
temperature input screen.
2 Use [<] and [>] to select an input digit, use [Λ] and [V] to change the value, and press [●] (Confirm).
The valid setting ranges are as in the table below.
Model
USX, EDGE Series
SFMC Series 4, 5
CAONS700
Heat Recovery CAONS
Series 1
Heat Recovery CAONS
Series 2
Set the demand current (for SFMC Series 4, 5, demand capacity).
Operation procedure:
1 Use [Λ], [V], [<], and [>] to select the system to change and press [●] (Confirm) to display the value input
screen.
2 Use [<] and [>] to select an input digit, use [Λ] and [V] to change the value, and press [●] (Confirm).
The range of values that can be input is "0" to "30000".
*
The initial value is "0". Note that if you enable demand/power saving with an incorrect setting, the unit will be
stopped.
Description
Cool PST [°C]
Initial
Setting range
value
7.0 4.0 to 30.0
7.0 5.0 to 25.0
– –
– –
30.0 9.0 to 35.0
31
32RCA001TS-02ISEN
Demand value input screen
Heat PST [°C]
Initial
Setting range
value
45.0 25.0 to 55.0
45.0 35.0 to 55.0
65.0 50.0 to 90.0
65.0 50.0 to 85.0
65.0 50.0 to 85.0