I/O Function List - Toshiba RBP-RC001-E Installation & Owner's Manual

RBP-RC001-E Installation & Owner's Manual

I/O function list

Digital Input functions
Function name
―
Run/Stop input signal
Stop input (pulse)
Operation pattern input 1
Operation pattern input 2
Input of demand mode
(Note 2)
Note 1: Run/Stop (static signal) can be changed to Run/Stop (pulses). For details, refer to "DN code setting (P. 41)" and "DN
code list (P. 51)". If Stop input (pulse) is set, Run/Stop input functions as the Run input (pulse).
Note 2: The initial value for the demand setting value is "0". Note that if you enable demand with an incorrect setting, the unit
will be stopped.
Digital Output functions
Function name
–
Operating output (Signal)
Failure output
Operation pattern output 1
Operation pattern output 2
Pattern interlock output1
Pattern interlock output2
* For details, refer to "DN code setting (P. 41)" and "DN code list (P. 51)".
Setting
classification
― No function
Used to perform Run/Stop operations with external static signals.
(Note 1)
Used to perform a Stop operation with an external pulse signal.
Enabled when the remote controller is set to External.
All
Switch the remote controller operation pattern with a combination of
input signals of the operation pattern input.
Used to enable demand from outside.
Setting
classification
– No function
GR outputs during operation. (Also output when the compressor is
stopped with capacity control.)
You can change the output method by setting "Level of operating
output".*
Output when GR detects a failure.
All
You can change the output method by setting "Level of failure output".*
Outputs the operation pattern state with a combination of operation
pattern outputs.
Outputs the state of the pattern interlock output setting of the selected
operation pattern.
Details
Details
50
32RCA001TS-02ISEN
Initially set
terminal No.
Not set
DI1
Not set
DI2
DI3
Not set
Initially set
terminal No.
Not set
DO1
DO2
Not set
Not set
Not set
Not set