Advertisement
210MM
MITRE SAW
ORIGINAL INSTRUCTIONS
MAINTENANCE
TROUBLESHOOTING
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall out let.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is normal
and does not indicate a problem.
Worklight or laser line is not turning on
The worklight only turns on once a charged battery is fitted and the worklight or laser
light switch is switch on.
Ensure the light source is not covered in dust. Use a dry cloth to wipe away dust.
Mitre Saw Tips
Allow the saw to reach full speed before beginning a cut.
Never force the saw. Use light and continuous pressure.
When cutting is interrupted, to resume cutting, start the saw and allow the blade to
reach full speed, re-enter the cut slowly and resume cutting.
When cutting across the grain, the fibres of the wood have a tendency to tear and lift.
Advancing the saw slowly minimizes this effect.
MAINTENANCE
• Keep ventilation slots of the mitre saw clean at all times to ensure efficient
operation.
• After each use, blow air through the tool housing to ensure it is free from all dust,
dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and shorten
the life of the tool.
• Empty the dust bag regularly.
• If the housing of the saw requires cleaning, do not use solvents but a moist soft cloth
or soft brush only.
• Never let any liquid get inside the tool, never immerse any part of the tool into liquid.
• No lubrication is necessary as the tool has sealed bearings.
• When not in use, the mitre saw should be stored in a dry, frost free location not
within the reach of children.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the circular saw by an unauthorised person or by mishandling
of the circular saw.
OZITO UK
Champion's Business Park, Unit 10, 1st Floor, Arrowe Brook Road, Upton, Wirral, Merseyside, CH49 0AB
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERY IS
REMOVED PRIOR TO ANY MAINTENANCE.
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
STANDARD EQUIPMENT
Compound Mitre Saw
Dust Bag
Material Clamp
Hex Key
PXCMSS-210U
Art.-No.: 30.003.44
I.-No.: 11018
Advertisement
Table of Contents
Related Manuals for Ozito PXCMSS-210U
Summary of Contents for Ozito PXCMSS-210U
- Page 1 Mitre Saw Tips Note: Ozito Industries will not be responsible for any damage or injuries Allow the saw to reach full speed before beginning a cut. caused by the repair of the circular saw by an unauthorised person or by mishandling Never force the saw.
- Page 2 1. CHANGING THE BLADE 2. SAW ALIGNMENT WARNING! ENSURE THE TOOL IS SWITCHED OFF AND The mitre saw should be set-up fairly accurate out of the box, but if the saw DISCONNECTED FROM THE POWER SUPPLY BEFORE becomes misaligned, you can follow the instructions below to adjust the tool. PERFORMING ANY OF THE FOLLOWING TASKS.
Need help?
Do you have a question about the PXCMSS-210U and is the answer not in the manual?
Questions and answers