Juniper SSG 5 Serial Hardware Installation page 15

To transfer files between the USB storage device and an SSG 5, perform the
following steps:
1. Insert the USB storage device into the USB port on the security device.
2. Save the files from the USB storage device to the internal flash storage on the
device with the save {software | config | image-key} from usb filename to
flash CLI command.
3. Before removing the USB storage device, stop the USB port with the exec
usb-device stop CLI command.
4. It is now safe to remove the USB storage device.
If you want to delete a file from the USB storage device, use the delete file
usb:/filename CLI command.
If you want to view the saved file information on the USB storage device or internal
flash storage, use the get file CLI command.
15
Back Panel