Juniper SSG 5 Serial Hardware Installation page 28

SSG 5 Hardware Installation and Configuration Guide
NOTE:
28
Default Device Settings
To unset ethernet0/3 from bgroup0 and assign it to the Trust zone with a static IP
address of 192.168.3.1/24, use the WebUI or CLI as follows:
WebUI
Network > Interfaces > List > Edit (bgroup0) > Bind Port: Deselect
ethernet0/3, then click Apply.
List > Edit (ethernet0/3): Enter the following, then click Apply:
Zone Name: Trust (select)
IP Address/Netmask: 192.168.3.1/24
CLI
unset interface bgroup0 port ethernet0/3
set interface ethernet0/3 zone trust
set interface ethernet0/3 ip 192.168.3.1/24
save
Table 5: Wireless and Logical Interface Bindings
SSG 5-WLAN
Wireless Interface
Specifies a wireless interface, which is
configurable to operate on 2.4G and/or
5G radio
Logical Interfaces
Layer-2 interface
Tunnel interfaces
You can change the default IP address on the bgroup0 interface to match the
addresses on your LAN and WLAN. For configuring a wireless interface to a bgroup,
see "Basic Wireless Configuration" on page 33.
The bgroup interface does not work in Transparent mode when it contains a
wireless interface.
For additional bgroup information and examples, refer to the Concepts & Examples
ScreenOS Reference Guide.
There are no other default IP addresses configured on other Ethernet or wireless
interfaces on a device; you need to assign IP addresses to the other interfaces,
including the WAN interfaces.
Interface
wireless0/0 (default IP address is
192.168.2.1/24).
wireless0/1-0/3.
vlan1 specifies the logical interfaces
used for management and VPN traffic
termination while the device is in
Transparent mode.
tunnel.n specifies a logical tunnel
interface. This interface is for VPN
traffic.
Zone
Trust
Null
N/A
N/A