Table of Contents
Advertisement
Cleaning and care
Descaling warning
Descale soon
will appear in the dis-
play the next time you switch the steam
ironing system on if there are only about
2 hours of ironing available before the
system needs descaling.
You can start the descaling process
whilst the system is cold via the Set-
tings menu (see "Starting the descaling
process early") or you can press the OK
button to confirm the message in the
display and continue ironing as normal.
The symbol will continue to show in
the display until descaling is carried out.
After the remaining operating hours
have elapsed, the descaling process
must be carried out before the steam
ironing system can be used again.
You can also start the descaling pro-
cess at a time that suits you (see
"Starting the descaling process
early").
You can interrupt the descaling process
by switching the steam ironing system
off with the button. When you switch
the system back on, descaling will start
again from the point where the process
was interrupted.
The messages in the display will guide
you through the descaling process. The
entire descaling process takes approx.
90 minutes.
Only proceed with stages of the pro-
cess when prompted to do so by the
appropriate message in the display.
Once the descaling process has star-
ted, your presence is required after
around 20 minutes and again after a
50
further 60 minutes. For the rest of the
descaling process, you can leave the
steam ironing system unattended.
Tip: To optimise the descaling process,
start the procedure while the system is
still cold after switching the steam iron-
ing system on. This way, you will avoid
a delay of up to 3 hours that may be
caused by the cooling phase.
Advertisement
Table of Contents
