Intercode Delay - Datalogic Quickscan QD2200 Product Reference Manual

REFERENCES

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The select-
able range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 =
3. Go to page 86 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
4. Scan the bar code: SELECT INTERCODE DELAY SETTING on
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
Table 9 - Intercode Delay Setting Examples
STEP
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan two characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
156
QUICKSCAN™ I QD2200
05, 20 = 20, etc
Programming Mode.
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
Appendix D
EXAMPLES
No Delay 5 seconds 60 seconds
00 05
'0' and '0' '0' and '5'
.
page 34
, that represent the
99 seconds
60 99
'6' and '0' '9' and '9'