Label Id: Set Individually Per Symbology - Datalogic Quickscan QD2200 Product Reference Manual

REFERENCES

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as
3. Scan a bar code to select the symbology for which you wish to configure a custom
4. Determine the desired character(s) (you may choose up to three) which will repre-
5. Turn to the ASCII Chart on
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 4 Label ID Position Options
Prefix
162
QUICKSCAN™ I QD2200
suffix) by scanning the appropriate bar code in the section "
. Reference Figure 4 for Label ID positioning options if multiple identifica-
page 42
tion features are enabled.
Label ID from the section "
sent the Label ID for the selected symbology.
find the equivalent hex digits associated with your choice of Label ID. For example,
if you wish to select an equal sign (=) as a Label ID, the chart indicates its associ-
ated hex characters as 3D. Turn to Keypad, in
representing the hex characters determined. For the example given, the charac-
ters '3' and 'D' would be scanned. More examples of Label ID settings are provided
in Table 11 on page 163.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
Label ID Aim ID
Label ID Symbology Selection" on page 43
on the inside back cover of this manual and
page 204
Appendix D
Bar Code Data
OR
Label ID Control" on
.
, and scan the bar codes
Label ID Suffix