Set Length 2 - Datalogic Quickscan QD2200 Product Reference Manual

Table 16 Length 1 Setting Examples
ACTION
STEP
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 1 SETTING for the desired symbology
Scan two characters from
4
Appendix D
5 Scan ENTER/EXIT PROGRAMMING MODE

Set Length 2

This feature specifies one of the bar code lengths for a given symbology. Length 2 is the
maximum label length if in Variable Length Mode, or the second fixed length if in Fixed
Length Mode.
Reference the Symbologies section on
characters) for the symbology being set. A setting of 00 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading zeroes to
yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
length setting which was determined in the steps above. You will hear a two-beep
indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
EXAMPLES
01 Character 07 Character 52 Character 74 Character
'0' and '1' '0' and '7'
to view the selectable range (number of
page 65
SYMBOLOGIES
'5' and '2' '7' AND '4'
, that represent the
Appendix D
PRODUCT REFERENCE GUIDE
171