Attaching The Transfer Module; Attaching The Clamp To The Transfer Module - Verathon Aperture User Manual

2 Setting Up

Attaching the Transfer Module

After the clamp is attached to the Transfer Module, the Transfer Module
can be mounted on a monitor stand, an IV pole, or an equipment rail.

Attaching the Clamp to the Transfer Module

To attach the clamp to the Transfer Module:
1. Unscrew the tilt knob, and remove the washer.
2. Attach the Transfer Module to the Transfer Module clamp by re-
installing and tightening the Tilt Knob. Insert the washer between the
two brackets. Figure 7 shows the top view of this step.
Rotation Knob
Parts:
Transfer Module
Transfer Module Clamp
Figure 7
page 28
0570-0192
0130-0227
Aperture™ Surgical Surveyor User's Manual
Tilt Knob
Rubber Washers