Rack-Mounting Requirements; Installation Tools - HP A5820X Series Installation Manual

Table 4 Limits on harmful gases in the equipment room
Gas Maximum concentration (mg/m
SO 0.2
2
H S 0.06
2
NH 0.05
3
Cl 0.01
2

Rack-mounting requirements

Before rack-mounting a switch, make sure the rack meets the following requirements:
HP recommends that you mount a switch in an open rack. If you mount a switch in a closed rack,

make sure there is a good heat dissipation system.
 Make sure the rack is steady enough to support the switch and accessories.
 Make sure that the switch fits the rack size. Leave some spaces beside the left and right panels of the
switch for chassis heat dissipation.

Installation tools

Flat-blade screwdriver

Phillips screwdriver

ESD-preventive wrist strap

All these installation tools are user supplied.
3 )
3