HP A5820X Series Installation Manual page 25

Figure 21 Connecting the grounding cable to the grounding hole of switch
(1) Chassis rear panel
(3) Grounding hole
(5) Grounding cable
Remove the hex nut of a grounding post on the grounding strip.
4.
Cut the grounding cable as appropriate for connecting to the grounding strip.
5.
Peel 5 mm (0.20 in) of insulation sheath by using a wire stripper, and insert the bare metal part
6.
through the black insulation covering into the end of the OT terminal. (The switch comes with two
OT terminals. Select the OT terminal appropriate to the size of the grounding post.)
Secure the metal part of the cable to the OT terminal with a crimper, cover the joint with the
7.
insulation covering, and heat the insulation covering with a blow dryer to completely cover the
metal part.
Connect the OT terminal to the grounding pole of the grounding strip, and fasten it with the
8.
removed hex nut.
Figure 22 Connecting the grounding cable to a grounding strip
(1) Grounding post
(3) Grounding cable
(2) Grounding sign
(4) OT terminal
(6) Grounding screw
(2) Grounding strip
(4) Hex nut
19