Table of Contents
Advertisement
1
For your safety
107812_en_00
1.1
Intended use
The TC MOBILE I/O... devices monitor digital values via the mobile network and switch
relay outputs. The data is transmitted depending on series via SMS, e-mail or the ODP pro-
tocol.
Operation of the wireless system is only permitted if accessories available from Phoenix
Contact are used. The use of other accessory components could invalidate the operating
license. You can find the approved accessories for this wireless system listed with the
product at phoenixcontact.net/products.
1.2
Warning instructions
Only for the DC devices TC MOBILE I/O X200 and TC MOBILE I/O X300:
WARNING: Risk of electric shock
During operation, certain parts of this device may carry hazardous voltages. Disregarding
this warning may result in property damage and/or serious personal injury.
–
Provide overcurrent protection (I ≤ 6 A) within the installation.
–
The power output of the power supply unit must not exceed 240 VA.
Only for the AC devices TC MOBILE I/OX200 AC and TC MOBILE I/O X300 AC:
WARNING: Risk of electric shock
During operation, certain parts of this device may carry hazardous voltages. Disregarding
this warning may result in property damage and/or serious personal injury.
–
Never carry out work on live parts.
–
This device is not suitable for monitoring sensitive systems or time-critical processes.
GSM network failures or power supply interruptions may adversely affect monitoring.
–
The device is intended for installation in a control cabinet or a comparable container.
The device may only be operated when it has been installed. The control cabinet
must meet the requirements of EN/IEC 60950-1 in terms of fire protection shielding.
Additionally, it must provide adequate protection against electric shock (protection
against contact).
–
It must be possible to disconnect the device from the power supply. Install an appro-
priate disconnecting device (fuse, miniature circuit breaker, etc.) for this purpose.
–
During electrical installation, observe the current standards and regulations. Installa-
tion must be carried out by an expert.
For your safety
7
PHOENIX CONTACT
Advertisement
Table of Contents
