Introduction; Help From Etc Technical Services - ETC Power Control Processor Mk2 Configuration Manual

For use with echo relay panel mains feed, echo relay panel feedthrough, and the sensor iq intelligent breaker panel

Hide thumbs Also See for Power Control Processor Mk2:

Table of Contents

Introduction

Congratulations on your purchase of a product that utilizes the Echo Power Control Processor

Mk2. This manual contains basic maintenance and service procedures along with information

on using the Power Control Processor Mk2 with the following products:

• Echo Relay Panel Mains Feed (ERP)

• Echo Relay Panel Feedthrough (ERP-FT)

• Sensor IQ Intelligent Breaker System

Each of these products provides professional-quality switching of dimmed and non-dimmed

loads controlled by DMX-512 or Ethernet.

If you have questions that are not answered by this document, try the ETC support website at

support.etcconnect.com

resources are sufficient, contact ETC Technical Services directly at one of the offices identified

below. Emergency service is available from all ETC offices outside of normal business hours.

When calling for help, take these steps first:

• Prepare a detailed description of the problem

• Go near the equipment for troubleshooting

• Find your notification number if you have called in previously

Please have the following information handy:

• Your location and job name

• Model of breaker or relay panels

• Type of relays and breakers used including the model numbers and quantities

• All option cards installed in the panel

• Other components in your system including dimmers, switch gear, etc.

• DMX or network control source used for system-wide control, if any

• Related system problems or equipment failure

or the main ETC website at etcconnect.com. If none of these

Table of Contents

Do you have a question about the Power Control Processor Mk2 and is the answer not in the manual?