Safety* Explanation of signal CAUTION Do not operate equipment without words for safety wearing personal protective gear. The assembly must be installed, maintained Wear eye protection. Protective and repaired exclusively by persons familiar equipment such as dust mask, non-skid with the instructions.
Page 6
Description Model oil pump is used as the pumping unit for a centralized lubrication system having a single line circuit of SL-, SL-, SL- or SL- injectors. It is an air operated reciprocating pump that discharges an established amount of lubricant (.in ...
Page 7
Fig. 16 / in (413 mm) 14 / in (362 mm) 23 / in (591 mm) 2 / in (63,5 mm) 30 33 9 in (228 mm) ) Restrictor may be added between tee () and plug () to reduce pump noise. Pump speed and output per minute will be reduced accordingly.
To fill reservoir To prime system Operation Supply lines Lubricant reservoir is filled through filler cap () at top of reservoir. Strainer () Lube cycle initiates when pump times out. is located in filler cap. Strainer should be Allow lubricant to bleed around vent plug to Air solenoid is energized to deliver air to removed from filler cap and cleaned expel air pockets trapped between pump...
Page 9
Fig. IPB / in NPTF 92 93 / in NPTF / in NPTF / in NPTF / in NPTF / in NPTF / in NPTF ) Torque to ft.lbf. (, to , Nm). ) Air exhaust port ) Torque ...
Page 10
Service parts Item Description Part number Quantity Item Description Part number Quantity Lock washer Screw Hex head screw Gasket (neoprene) ) Plug button Screw ...
Troubleshooting Problem Cause Solution Pump operates continuously. Pump has lost prime. Examine lubricant supply. Refill reservoir if necessary. Air pocket trapped in lubricant. Loosen vent plug one turn. Allow pump to operate until trapped air is pumped out. Close vent plug. Pump continues to operate without discharging Pump check () and steel ball () Remove and clean checks and check seats.
Need help?
Do you have a question about the H Series and is the answer not in the manual?
Questions and answers