Logging In To The App; Used With The Ups2000-H-6/10Krtl-L - Huawei SmartLi-ESM-24020P1 Quick Manual

SmartLi-ESM-24020P1
Quick Guide
Fully charge batteries (the SOC must reach 100%) before using them for the first
time. Replace a battery only if it is faulty.
Step 1 Power on the UPS.
Step 2 If a BBB box is used, press the PRESS button on the BBB box to open the front
cover and turn on the switch of the BBB box. If no BBB box is used, skip this step.
Step 3 After the UPS runs stably in normal mode for 3 minutes, observe the running
indicator on the front panel of each battery module. Perform
battery module whose indicator is off. If the battery indicator is on, skip
Step 4 Press and hold the activate button on the front panel of the battery module for 5s
to 10s. After the running indicator turns on, release the activate button.
----End

2.3 Logging In to the App

2.3.1 Used with the UPS2000-H-6/10KRTL-L

Step 1 Use a mobile phone browser to scan the QR code on the front panel of a battery
module to download and install the NetEco app.
Issue 03 (2022-12-30)
CA UTION
NO TE
If Running mode is set to Lithium battery on the app, the battery module automatically
powers off if it does not communicate with the UPS2000-H-6/10KRTL-L within 300 minutes
(the UPS2000-H-6/10KRTL-L is not powered on or the communications cable between the
battery module and the UPS2000-H-6/10KRTL-L is not connected) to avoid power
consumption after power-on.
NO TE
When the SmartLi is used with the UPS2000-H-6/10KRTL-L, the SmartLi version must be
UPS2000 V200R022C10SPC100 or later.
NO TE
When the SmartLi is used with the UPS2000-G-15/20KRTL-01, the SmartLi version must be
UPS2000 V200R022C10SPC120 or later.
NO TE
● A maximum of two mobile phones can be connected to the WiFi network, and only one
mobile phone can be used to log in to the app.
● When logging in to the app, select Allow for all permission dialog boxes displayed on
the mobile phone.
● When you connect the mobile phone to the WiFi network of the SmartLi, it is
recommended that you disable the WLAN+ function on the phone. Enabling the WLAN+
function will let the mobile phone automatically connect to the network with the
strongest signal, which may result in WiFi connection failure.
● GPS should be enabled on the mobile phone to obtain the WiFi name.
● For the first login, you need to enter the WiFi password.
Copyright © Huawei Digital Power Technologies Co., Ltd.
2 Power-On Commissioning
Step 4 on each
Step 4.
50