Brita sodaTRIO Usage Instructions page 9

5. Troubleshooting
Problem
Only a small amount of CO
reaches the water bottle.
Droplets of water are visible on the cylinder slot.
CO is escaping, but I am not pressing the
2
sparkling button button.
The cylinder gets extremely cold / freezes up.
The container can not be screwed in properly into
the soda maker.
After sparkling, there are small pieces of ice in the
water.
, or none at all,
2
Potential solution
Make sure, that a full CO
installed before.
Make sure, that the bottle is filled with
drinking water up to the marked filling line.
Make sure that you fully press down the
sparkling button.
Keep the sparkling button pressed down
until you hear a clear buzzing sound (2-3
seconds). Do not release the button until
you hear the buzzing sound.
Check if the CO cylinder is properly
2
screwed in.
The cylinder has run out of CO
replacing.
If you are using the small stainless steel
bottle, make sure that you have inserted
the bottle base before.
Try to screw in the CO
tightly.
Remove the cylinder and screw it in again.
Remove the cylinder. Check if there is a
black rubber gasket inside the cylinder
bracket and if it is properly centred. If the
rubber gasket is missing, please contact
BRITA customer service.
Make sure, that the bottle is inserted
properly into the container.
Make sure, that you have screwed in the
container into the system with the nozzle
centered in the upper part of the bottle.
No worries, this can occur with strong
sparkling of very cold water and is not a
defect.
cylinder has been
2
and needs
2
cylinder bit more
2
9