Brita sodaTRIO Usage Instructions page 5

The following instructions apply to all BRITA sodaTRIO bottles (glass, plastic and stainless steel):
• All sodaTRIO bottles incl. lids are dishwasher safe.
• Bottles have to be put into the dishwasher or must be cleaned by hand using only mild
detergent, before using them for the first time. Further, it is recommended clean the bottles on
a regular basis.
• When using a brush (e.g. made of silicon), make sure it is suitable for cleaning glass, plastic
and stainless steel bottles and must not have any exposed metal components, that could leave
scratches on the surface or the inside of the bottle.
• Water in the sodaTRIO bottles must not be carbonated by children.
• Before every use, check the sodaTRIO bottles for cracks or distortions. Damaged bottles must
not be used!
• The bottles must only be filled up to the specified filling level.
• In regular use, all bottles are only suitable for temperatures between 5°C and 40°C. In the
dishwasher, rinsing programs must not exceed 55°C.
• Do not put the bottles in the freezer or microwave.
• Do not expose the soda TRIO bottles to large temperature fluctuations (e.g. do not pour hot
water into a cold bottle or vice versa).
• Always store the empty sodaTRIO bottles with the lid removed.
• Do not leave the soda TRIO bottles in the car.
• Dropping a glass bottle filled with carbonated water can lead to cracks in the glass and
possibly cause the bottle to burst. Therefore, check with special care and dispose the bottle if
necessary.
• High pressure is created inside the bottle during carbonation, and for safety reasons, sodaTRIO
plastic bottles must be replaced no later than 24 months after purchase. This does not apply to
sodaTRIO glass bottles and stainless steel bottles.
• Important: If a sodaTRIO glass bottle is unexpectedly damaged during the sparkling process
(e.g. burst or break), please do not use the sodaTRIO anymore due to potential risk of splinters.
Carefully unscrew and empty the container and contact the BRITA customer service to prepare
a return delivery of the soda maker to BRITA.
Using CO safely
2
WARNING!
• The BRITA sodaTRIO can be operated with standard 425 g CO
in valve, but it is recommended using original BRITA CO
• Do not use larger or smaller CO
• Always use the soda maker with bottles filled up to the filling line! Never fill an empty bottle
with CO .
2
• CO cylinders may be very cold after use. Please wait for 10 minutes after your last use before
2
changing the cylinder.
• When storing, CO
2
prevented from rolling or falling. For safety reasons, the cylinder must never hit the floor with
the valve upfront in order to avoid its damage which could cause a potential gas leak. When
operating, always place CO
• Full CO cylinders must never be exposed to direct sunlight or temperatures above 50°C.
2
• Store CO cylinders, whether full or empty, out of reach of children.
2
• CO is a colourless, odourless gas. There is a danger of suffocation in situations with high
2
concentrations and poor ventilation.
• If you suspect increased CO
• Damaged CO cylinders should not be used and must be exchanged without delay!
2
• In cases of improper use, the pressure inside a CO
injuries.
• Never attempt to fill the CO
• Do not make any alterations to the CO
• Do not insert or replace a CO
cylinders under any circumstances.
2
cylinders can be placed vertically or horizontally, but be sure that they are
cylinders in an upright position.
2
concentration in a room, ventilate and leave the area.
2
cylinder yourself.
2
2
cylinder in the sodaTRIO if a sodaTRIO bottle is still inserted.
2
cylinders.
2
cylinder can cause serious and even fatal
2
cylinder, such as piercing it, etc.
cylinders with universal screw-
2
5