Page 1
PURITY 1200 Clean/ PURITY 1200 Clean Extra Wasserfi ltersystem / Water Filter System Handbuch deutsch Handbook english Mode d’emploi français Handboek nederlands Manuale italiano Manual español Podręcznik polski Manual dansk...
Page 2
Deutsch 1 Begriffsübersicht 2 Allgemeine Informationen 3 Betriebs- und Sicherheitshinweise 4 Installation 5 Inbetriebnahme eines Neufi lters 6 Austausch der Filterkartusche 7 Filterkapazität 8 Instandhaltung 9 Fehlerbehebung 10 Technische Daten 11 Bestellnummern English 1 Defi nition of Terms 2 General Information 3 Operating and Safety Information 4 Installation 5 Commissioning a New Filter...
2.2 Guarantee Provisions The PURITY 1200 Clean and PURITY 1200 Clean Extra fi lter systems are subject to the statutory guarantee of 2 years. A guarantee claim may be asserted only if all instructions in this Handbook are followed and observed.
Page 5
Comply with local regulations and bring the units to be disposed of to a proper recycling facility at the collection points provided. Exhausted fi lters are taken back by BRITA at the addresses listed on the back of the cover.
Page 6
• No copper pipes and no galvanised or nickel-plated pipes/connectors may be installed between the water fi lter and the consumer. The use of Brita hose sets is recommended here. When choosing the material for parts that come into contact with water after the BRITA fi...
PURITY 1200 Clean Extra fi lter cartridge. 1x manual 1x carbonate hardness test or total hardness test 1x sticker for Service Pass, Note: Light blue sticker for PURITY 1200 Clean, red sticker for PURITY 1200 Clean Extra. 1x reducer 1”– 3/4”...
Page 8
The bypass setting screw be increased to 10% according to the local water quality or application in question. If you have any questions about water quality, your supplier or your contact at BRITA will advise you. Note: Use Allen key 6mm or 7/32“ to adjust the bypass setting screw 5.2 Identifying the Filter Capacity...
Note installation date of the fi lter system on pressure vessel next exchange date on the enclosed sticker (PURITY 1200 Clean: light blue sticker, PURITY 1200 Clean Extra: red sticker) and attach it to the Service Pass on the pressure vessel 6 Exchanging the Filter Cartridge The fi...
Page 10
Place the used fi lter cartridge drainage (> 5 min). • Lock the used fi lter cartridge cartridge and return in the original packaging to the appropriate BRITA address listed on the back of the cover. 6.2 Inserting the Filter Cartridge •...
Regularly clean the outside of the fi lter system with a soft, damp cloth. Caution: Do not use any substances incompatible with the material (Chapter 3.4) or astringent, abrasive cleaning agents. 9 Troubleshooting 9.1 No water fl ow Cause: Water intake closed. Troubleshooting: Open water intake on the upstream stop valve or inlet valve hose Caution: The following faults may be remedied only by trained and authorised...
BRITA PURITY 1200 Clean / PURITY 1200 Clean Extra Article PURITY 1200 Clean (complete system with fi lter cartridge) PURITY 1200 Clean Extra (complete system with fi lter cartridge) PURITY 1200 Clean replacement cartridge PURITY 1200 Clean Extra replacement cartridge...
Page 14
Fax +34 93 342 75 71 http://professional.brita.net Information in the instruction for use subject to change BRITA ® , AquaQuell™ and AquaVend™ are registered trademarks of BRITA GmbH Germany BRITA AG Gassmatt 6 CH - 6025 Neudorf/LU Tel +41 (0)41 932 40 27 Fax +41 (0)41 930 30 74 http://professional.brita.net...