Brita sodaTRIO Usage Instructions page 6

3. Use
Select a suitable location for the BRITA sodaTRIO on a flat, stable surface away from heat
sources or open flames, such as stoves or ovens. The soda maker must not be operated above
40°C.
Always use the soda maker in an upright position.
Before use, make sure that the bottle and soda maker are in a clean condition.
Installing the CO
Caution: the sodaTRIO is only compatible with CO
cylinders (e.g. with quick connect valve) are not compatible.
If the container is attached to the system, please remove it from the soda maker.
Remove the drip tray grid and place the soda maker on its side.
Remove the seal on the CO
Slide the cylinder carefully into the body from the bottom. As soon as the cylinder gets in
contact with the end, turn it in a clockwise direction. Screw in cylinder tightly, but not too
tightly, as this may cause damage to the system or the cylinder itself.
To remove an empty cylinder, reverse the procedure used to install the cylinder, ensuring that
you unscrew it in an anti-clockwise direction.
Screw the nozzle into the thread provided on the sodaTRIO.
Place the sodaTRIO in an upright position and insert the drip tray grid.
It's sparkling water time!
Before using the bottles for the first time, put
them into the dishwasher or clean them by hand
using a mild detergent and lukewarm water.
Now fill the bottle with water up to the
marked filling line. Do not fill above the
marking! If the sodaTRIO bottles filled
above this level, the water will overflow
when it is carbonated.
Please find the filling line of the stainless
steel bottles on the inside of the bottle.
6
cylinder and the soda maker
2
cylinder head and unscrew the valve cover.
2
cylinders with universal screw-in valve. Other
2