Additional Information; Disc Care - Onkyo DV-M301 Instruction Manual

Additional
Information

Disc Care

DISC CAUTIONS WHEN USING THIS
CHANGER
• When changing or inserting discs, make sure that the
rack is stopped. Do not attempt to load a disc into the
changer when the rack is moving.
• Never insert more than one disc at a time into one
slot. This can scratch or damage the discs.
• To prevent malfunction, be sure to use an adapter
when loading 8 cm (3 in.) CDs in the changer.
• To prevent malfunction, do not use 8 cm (3 in.) CD
adapters with 8 cm (3 in.) DVDs.
HOW TO HOLD DISCS
When loading or removing discs, try not to touch their
playing surfaces.
CLEANING
Fingerprints or other dirt on the disc may affect sound
and picture quality.
To clean your discs, use a soft clean cloth to wipe them.
If necessary, moisten a soft cloth with diluted neutral
detergent to remove heavy dirt or fingerprints.
Do not wipe in a circular
direction (Concentric
scratches in the disc groove
tend to cause noise.)
Discs must not be cleaned with record cleaning sprays,
or static prevention sprays, etc. Also do not use volatile
liquids such as benzine, or thinner, etc.
LENS CLEANER
The changer's pickup lens should not become dirty in
normal use, but if for some reason it should malfunction
due to soiling, contact your nearest Onkyo authorized
service center. Lens cleaners are commercially available,
however their use is not recommended because some
may cause damage to the lens.
Gently wipe from the
inside toward the outer
edge.
NEVER PLAY CRACKED OR WARPED DISCS
The disc revolves in the changer at high speed when it is
played. Never play a cracked, scratched or warped disc.
This may damage the changer or cause it to malfunction.
NEVER USE DISCS WITH SPECIAL SHAPES
CD's with special shapes (heart-shaped CDs, octagonal
CDs, etc.) cannot be played on this set.
Attempting to do so may damage the set. Do not use
such CDs.
CAUTION WHEN USING THE DISC
All rights reserved.
Unauthorized public performance, broadcasting or
copying is a violation of applicable laws.
Notes on using optical cables
• Do not route cords around sharp angles. When
storing, wind the cords so that they have a diameter
of at least 15 cm (6 in.).
• When connecting, push all the way into the jack.
• Do not use cords with a length of over 3 m (10 ft.).
• If moisture or dust has collected on the plug, wipe it
with a soft cloth before connecting.
15 cm (6 in.)
dia. or more
71