Check Pressure; Camera Pressurization - Envirosight Verisight Pro+ Original Instruction Manual

Table of Contents

Advertisement

Check Pressure

The camera pressure bar displayed on the right hand side of the display will either
show a red bar with LO written within it or it will be green with the pressure
written within it in mBar.
The Pan & Rotate camera must only be used when the bar is green.
To pressurise the camera see the pressurization section below.
CAUTION! Attempting to record a video when the camera
pressure is displayed LO in a red bar will display a warning on
screen to the operator:
The camera pressure is low! Using the camera with low pressure will
void the warranty and may damage the camera!
If you still wish to record with the camera now, press the Y key to confirm, or
press ESC to cancel.
If the camera is used with low pressure this information is recorded inside the
camera and the warranty void.
Pressing the menu key when the joystick camera control is enabled will
automatically disable it to allow the operator control of the menu system. The
operator must enable the joystick camera control manually afterwards.

Camera Pressurization

To pressurize the Pan & Rotate camera it must be connected to the Verisig ht
Pro+ . If not already done so, follow the instructions - Basic Camera Operation
(opposite) to get the camera working first.
1 Move the camera with the joystick to allow easy access to the valve on the
side.
2 Unscrew the protection cap from the camera and screw in the recharge valve.
Version A
Envirosight Verisig ht Pro+
93

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Verisight Pro+ and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF